How to Wash-Dry your Car – It’s the weekend! How good it is to wash your car and detail it at the same time. Through washing, you can remove certain debris that comes into contact with your car. You’ll be amazed at how much dirt builds up inside and outside your car. Washing is like a shower, however, you can do a car shower only once or twice a month and that will be enough.
All car detailing processes start with washing your car and then everything else will follow. You can’t wear new clothes and perfumes without bathing now, right? Well, for some people it is, but that’s not really the way to go.
How to Wash-Dry your Car
How do you get things with the proper washing techniques of your car? Read…
The rinse will be done at the beginning and at the end you will bathe the car. You need to rinse your car thoroughly to clean some removable dirt and those that have been stacked will soften. Use a hose with overflowing water, but make sure the flow isn’t hard enough to damage your car or soft enough that it doesn’t reach its destination. Hard water flow can also be the cause of car scratches, so excessive water pressure is not recommended. Retailers prefer that water flow freely from the top of the car or out of the hose by having to use a nozzle.
When you “lag” your car, be sure to use the type of detergent specifically designed for your car and not just what you use in the kitchen or in your bathroom. Don’t use dish soap or liquids because these things are too strong, which will contribute to scratches on your car and remove wax.
In a simpler context, that’s all there is. After preparing your equipment and tools, you can now mix your detergent according to the manufacturer’s instructions. Dip your gloves or sponge in a bucket of water containing the mixed solution. Before you do anything else, you should follow these guidelines to improve the safety of your car.
• Be generous with your water and detergent. You can use an average of 3 or 4 buckets of water for small cars and 5 to 6 buckets for medium cars.
• Washing should be done in several parts. Start at the top. This will allow rinsing to be relatively easier. After making the roof, you can proceed to the door, fenders and other parts of the car. Be sure to do a full rinse between the parts. After applying soap, you need to rinse so that the film does not develop. The foams will make the soap dry and make the stain ugly.
• Right after washing the part, you need to wash or rinse the entire body of the car. Use large amounts of water so that all the soap is washed thoroughly. Do not leave gaps, cracks, and corners where soap can seep in and hide.
If you are not satisfied with the first wash, do it a second time. It’s better to see acceptable results than to be satisfied with what you’re doing. Not bad to wash a second time because in detail the first wash is just your way of introducing cleaning.
The first wash has taken care of most of the visible dirt and the second will do the rest of the dirt. That’s what a good car detail is all about.